From 736cfef1845df9cc76f55e6fa5280687e942ec36 Mon Sep 17 00:00:00 2001 From: Ivana Date: Thu, 9 Jun 2022 10:23:37 +0000 Subject: [PATCH] Update autostart mailbox on reboot when mailbox set up not completed yet --- ...t-when-mailbox-set-up-not-completed-yet.md | 20 ++++++++++++------- 1 file changed, 13 insertions(+), 7 deletions(-) diff --git a/autostart-mailbox-on-reboot-when-mailbox-set-up-not-completed-yet.md b/autostart-mailbox-on-reboot-when-mailbox-set-up-not-completed-yet.md index c218d54..0932457 100644 --- a/autostart-mailbox-on-reboot-when-mailbox-set-up-not-completed-yet.md +++ b/autostart-mailbox-on-reboot-when-mailbox-set-up-not-completed-yet.md @@ -1,17 +1,23 @@ Seb's insturctions: -Scenario 2 (restarting device does not start mailbox on boot if mailbox was set up but was stopped before reboot) +Scenario 3 (restarting device starts mailbox on boot if mailbox setup has been started but not finished yet, i.e. setup has reached qr-code stage, but pairing not yet complete for example because just not scanned by briar yet) -* Set up mailbox on a fresh device and pair it with briar or reuse paired setup from scenario 1 and start the mailbox app. -* Stop the mailbox app using the "Stop" button from the status screen. -* Restart device. Confirm that mailbox **does not start** automatically after boot. As it can take quite a while this needs to be observed for a couple of minutes. Good to take into consideration the amount of time it took for the mailbox app to start automatically in scenario 1. +* Reset data for mailbox app or uninstall and reinstall. +* Start mailbox app, proceed until qr code is visible. +* Restart device. Confirm that mailbox app **does start** up automatically after boot Steps to execute: -As described above. +Try to restart the Mailbox device at different points during the onboarding process: -When the mailbox does not autostart - the status should be reflected in Briar? **TBD?** +- during the intro screens (for example after the first couple of them) +- immediately after the 'do-not-kill-me' fragment has been disaplyed +- aftet eh "Allow connections" button has been tapped +- when the QR code is disaplayed +- Immediately after the QR code has been scanned by Briar but before the status screen shows 'connected' (if that is possible by user action) -Repeat with different devices, but also with restarting it manually immediately after reboot, or a few minutes/hours later... (should not make any difference, but just to be sure to be sure) +Use different devices for different steps, or even a few devices for each step to achieve better coverage. + +TBD - mailbox auto-restart shows **.. screen... ** which screen should be shown to the user after the mailbox auto-restart? [Back to Testing](https://code.briarproject.org/briar/briar/-/wikis/testing) \ No newline at end of file